thin materials and high accuracy requirements

Double-layer fabric (stickers) cut (upper cut through the next level there is no injury or minor injury). This is the process for the electronics industry, matching the laser light control accuracy, stability, and the speed of light intensity have a higher, we generally use domestic glass tube sampling, which can basically achieve the desired effect, but recommended for high-volume processing, imported radio frequency laser. Open the exhaust blowing, fabric flat adsorbed on the cellular on and to adjust the cellular base plate flatness of the four corners. Speed of light intensity settings: specific parameters according to the material, the two are able to achieve a better match. The final inspection of  laser pointer will be carried out by the specific quality inspector.  So that the safety of the user and others can be ensured for this kind of  laser pointer
General layer of 1.5-6 meters, the light intensity in the 18-35 or so; under a layer of light intensity speed there is no specific requirements under the premise of ensuring good incision quality can be as much as possible to open a little faster, another set of light intensity should have the difference, thus ensuring that the depth of cut in the acceleration and deceleration are consistent. (Some materials can not blow). Trademark cutting (cloth woven Mark, woven labels, trademarks). Trademark cutting mainly uses automatic camera and semi-manual cutting two operating modes, the accuracy mainly depends on the adjustment of the machine and positioning accuracy of each organization marks out some differences, each complete border cut impossible. Required for cutting our way with an ordinary cloth cutting almost. For this kind of  laser pointer , a piece of AAA battery is enough to switch on the laser pointer.
However, as Mark weaving trademark precision and hardness than the fabric is much greater in intensity and speed is quite different. The speed and intensity depending on the workpiece may be reference parameters: speed of 1.2-5 m / min, light intensity 20-55%. Acrylic cutting and engraving. There are a variety of plexiglass material, imported and domestic big difference, very smooth plexiglass cut out some made too many impurities, will be bubbly. The cutting of acrylic commonly used low-speed machine, because the laser tube power is not large, but thin materials and high accuracy requirements. The average speed over 3 m / min, such as the CMB series, the linear guide fine lines, smoothness or.